MAKING THAT SPLITTER MORE EFFECTIVE- Introducing a Universal splitter 3D printed using Carbon Fibre PETG plastic making it strong, heat resistant and chemical resistant. The diffuser is designed so that the mounting flange can be placed on the back side of the splitter to allow for a clean aero surface and no visible bolts or screws. The distance between the flange and the leading edge of the diffuser is 12mm, This dimension should be the same as the thickness of the board used for your splitter lip Diffuser dimensions: Total width (Inc flanges): 238mm Tunnel Width Front: 165mm Tunnel Width Rear: 185mm Total length: 231mm Tunnel length: 223mm Tunnel height: 50mm Install tips: Ensure adequate room in front of and behind diffusers to ensure airflow isn’t constricted for maximum performance. Designed to be simply screwed or bolted or bonded to a splitter. It is recommended to fit these using an adhesive such as tiger seal. Drilling and using screws can create an area where cracks can propagate from. Please ensure your splitter is properly attached to the car. These can, and will, create much more downforce and can rip the splitter from its mounts. YOU’VE BEEN WARNED!
